Voxengo Voxformer v1.1 released

21st June 2004

Voxengo have updated Voxformer to v1.1 which features a considerable number of improvements and enhancements.

Changes:

Listen "Comp A" and "Comp B" options added.
Comp B (when used in serial mode) was applied before Comp A. This was fixed: Comp B will work after Comp A now.
"In" gain control added. Using this control you can adjust any existing preset to suit the new program material you wish to apply this preset to.
Presence module type switch added. Now presence can be switched from the default "post" mode to the "pre" mode where it uses signal before it is fed into compressor, but mixes the output, like in the "post" mode, after compression takes place.
Gate meter added. It only shows the moments when gate is opening, this meter has no specific scale.
A rearrangement of controls introduced. Also, frequency scale labels under the equalizer screen were added.
Asymmetric compression mode implemented.
Minor speed-ups.
"Misc" control panel added. This panel features several additional module controls. De-esser's ratio control has been moved to this panel also. Beside this you can also adjust the bandwidth (inverse Q) of de-esser's side-chain filter, presence module's filter and you can also define saturator module's bias which gives you control over the harmonic content.
De-esser's gain reduction meter scale changed from 10 dB to 3 dB.
Steepness of de-esser's filter increased. This may require some minor fine-tuning of the existing presets.