Hey all!
I'm trying to make notes that I play more lightly be more muffled. Here's my attempt but it doesn't seem to do anything (all notes sound equally muffled).
I confess I haven't read the entire manual but I did read the Modulation section.
I would appreciate any hints.
TX16Wx - mapping velocity to filter cutoff
-
- KVRer
- Topic Starter
- 12 posts since 2 Sep, 2009
You do not have the required permissions to view the files attached to this post.
-
- KVRAF
- 2431 posts since 27 May, 2005 from Stockholm
You have your values way to low. Begin by setting the filter (unmodulated) to the value you wish it to be when at its most let-through (i.e. max velocity). Remember this value. Then adjust it to where you want the lowest velocity to place the cutoff. Now consider the difference. If your low is 2kHz (as in your picture), and your high is 10kHz, then you have a difference at about 2.25 octaves (2kHz * 2 = 4kHz - one octave. Times 2 again, 8kHz - two octaves, and 10Khz ~= 2kHz * 2 * 2 * 1,25). Thus your modulation value becomes 2700Ct (1200Ct == one octave).
TX16Wx Software Sampler:
http://www.tx16wx.com/
http://www.tx16wx.com/
-
- KVRer
- Topic Starter
- 12 posts since 2 Sep, 2009
Thanks so much! Your VST is awesome (if a little complex for my dumb head)!